too cool not to share, Tim’s advise is spot on with all the fine tips and tricks on how to rig these rings properly and without loosing them in the process !
many a time i’ve heard the recommendation of storing the rings on a small safety pin. please blindly accept that this is the last thing you want to do !
these pins are weak, open up when tightening the knot and all the unused rings spring out at the speed of sound never to be found again. (specially if this is done outdoors) this makes one feel really dumb and feeling really dumb is not good.
most tippet ring suppliers don’t supply a snap as seen in the video but they’re really cheap, can be found in the lure section (ughhh…) in tackle shops and the extra snaps from the pack can be used to secure various thingies in your vest or chest pack.
i’ve been using these rings for years now because they add a bit more versatility, reliability and visibility to my rigs. in other words, it makes changing, adapting and replacing much easier. it’s not like the ‘conventional’ method of directly joining mono to mono is of any problem, but i find myself being ‘less lazy’ when it comes to changing rigs with the rings than with mono-to-mono and this has without a doubt brought more fish to the net.
not mentioned in the video is they can also be used for multi-fly rigs. you can simply add on the dropper tippet forming a ‘T’ or better yet, as the Tangle-Free Duncan Dropper (highly recommended !)
as a side note and as in a lot of other equipment, be sure to have a good look at the rings before purchase as they are not all created equal. they shouldn’t have a rough or marked surface, nor should the weld be visible because scratchy surfaces scratch mono when tied on and scratch again later during use. not good. we don’t accept scratchy from hook eyes and the same should go here. you might want to bring a pocket loupe to the store…