to celebrate TLC’s shiny new face here’s some more than excellent tips on installing braided loops from Mike Barrio of Barrio Fly Lines.
the trick with the monofilament ‘threader’ really makes it easy to snug up the fly line end inside the braid and get it just right. enjoy !
Personally, I prefer to connect my leader directly to my fly line with a constriction type knot, in my experience this offers me a better transition from fly line to leader and better presentation. But braided leader loops are a very popular alternative method and I am frequently asked how to fit them.
There are numerous braided leader loops available on the market, many of these are too long and too heavy for most fly line tips and can cause them to sink, especially when fitted to lower weight lines. A lot of them are also very poorly made and can fail on a good fish. In my experience, the Roman Moser Minicon Loops are the best that I have found.
These are easy to fit. I usually grab 10 inches or so of nylon, thread it through the loop and hold it back in a ‘U’ against the loop ( loop through loop ) then I slide the red sleeve over the loop so that the sleeve is mostly sitting on the nylon.
Then I insert the fly line inside the braid at the other end and feed it up through the braid until it reaches the point where the loop is formed. Sometimes the end of the braid can be a bit tight making it difficult to insert the fly line, but if you push or prod the end of the braid with your finger this will help to loosen and expand the braid a little.
Now hold the nylon and slide the sleeve back over the loop and along the braid until it reaches the other end, I like to have about 3/4 of the sleeve sitting on the braid and 1/4 on the fly line.
A braided loop works by constriction, so the harder you pull the braided loop from the loop end, the more it will tighten and grip the fly line between the loop and the ‘sleeve anchor point’. Don’t be tempted to add a spot of glue at the loop end, as this could cancel out the constriction of the braid.
Braided loops work well when simply fitted like this, but some folk like the added assurance of a spot of waterproof superglue. If you wish to add waterproof superglue, stop sliding the sleeve just before you reach the end of the braid (picture 5) add a little glue to the end of the braid and then slide the sleeve over this to the 3/4 – 1/4 point. Only use a very small amount of glue, as slightly too much can cause your fly line tip to sink.
Hope this is useful 😎
as for TLC’ shiny new face, it was time to do some spring cleaning and since the rags and cleaning solution where out i thought i’d find a simpler, cleaner looking page layout that also works faster and better at home or with mobile devises.
since feedback always helps, please let me know if you’re having any viewing, navigation or whatever issues and i’ll work them out.
here’s hoping you like the new look and thanks again Mike !