in Good Knots we’d seen how
wind casting knots are a blessing in disguise but that’s just for the casting part. now, making tailing loops make us feel stupid, frustrated and all the well deserved ha-has from mates don’t help the situation however, and even though tailing loops don’t always result in casting knots, where the real nasty comes in is if we do get them and leave these knots unattended and carry on as if nothing happened.
general knowledge has stated for a long time that an overhand knot in a tippet or leader will reduce that section of mono to approximately one-half percent. in other words, a 10lb tippet instantly turns into a 5lb tippet. that sucks because it completely defeats the purpose of using a 10lb tippet in the first place and to make things even worse, if you think about the mates that saw you make that tailing loop and then see you break off on a fish, well, you know the rest…
the solution is simple and even if its a pain you have to pay for your mistakes; you (and i !) deserve it.
if you notice the ugly TL loop, immediately bring your line back in and check the leader. at this point, its not rare to find an un-seated knot like the ones to the left and all we need to do is undo it carefully, be sure there’s no kinks in it and if all looks good, resume fishing.
if the knot has seated tight that knot either has to be clipped off and rejoined with your preferred mono-to-mono knot or that section of tippet will have to be replaced if the casting knot is close to the fly or next to a mono-to-mono knot higher up the leader.
keep in mind that if you don’t take care of these casting knots, casting karma will come right back and bite you hard…
today’s video from Monsieur Simon Gawesworth removes any doubts about the up-till-now archaic 50% reduction breaking strain statement and the fishing world thanks him for it. enjoy ! (and take it easy when casting… 😉 )