Fly Casting Practice- Controlling Casting Stroke Force

experience tells me that apart from improper wrist control, the second most common difficulty many fly casters struggle with is force application throughout the stroke and to be more precise, they use too much force. way too much.

there are several ways to create tailing loops and they all have to do with the rod tip rising after dipping below the standard straight or slightly convex tip path in one manner or another but i’m firmly convinced as well as many of my instructor colleagues that the main cause is improper; too early or too much force application and often both are combined.
leaving aside for the moment that rod rotation (where most of the force is applied and the rod tip is going its fastest) should be done at the end of the stroke, today’s casting drill tip is about force quantity and to understand the point of the topic i’ll ask you to consider these two questions:
1) how many times have you seen a fellow angler drive their fly into the water surface (when that wasn’t the intended presentation) or make tailing loops or have the fly kick back or hook to one angle or another before landing ?
2) how many times have you seen a fellow angler cast a pile at the end of the line when they wanted a straight presentation ?
i’ll be very generous with no. 2 and give it an approximate 10%. even if that approximation is just a roundabout figure its quite obvious that there’s an overall higher tendency leaning towards the ‘more than necessary/too much’.

now, there are two methods to adjust how much force is being used:
– the first is the standard ‘do your normal cast’ and try to apply less force until its all nice and smooth with super control.
this a subtractive method. it may work and there’s nothing wrong with it but its a hard way as its much more difficult to ‘hold back’ and ‘unlearn’ an engrained movement, specially when its something we’ve been doing for a long time.
– the other method consists of doing the exact opposite, practising to cast lines that don’t turn over completely and ‘relearning’ to add a little more force, just what’s necessary to get the job done as we go along.
this is an additive method. one that’s quite easy to control because adding-on seems to correspond better to human nature than subtracting; we tend to ‘want more’ as opposed to ‘want less’ and its a method that works very well for people of all levels in all the various types of fly casting whether it be close/middle/long range, stream to sea, little to big flies and single or double handed.

since years ago i had been working on an almost exactly the same presentation cast -the Dunkeld Dump– (named after the city in Scotland where i first demonstrated this cast to a group of fellow casting geeks) and of course using it a lot for river fishing but it was only last year that i realised what a gem this was as a practice routine on its own when friend, colleague and super-caster Aitor Coteron wrote this article that set off so many lightbulbs: To straighten or not to straighten. That is the question.

here’s a slightly different full-on angle of this drill from one of last year’s casting-geek meets in Spain.

to conclude, just as mentioned in the link, i highly recommend doing this exercise at every practise session, preferably at the beginning.
to add some variety and improve one’s force control while still working on accuracy, a great thing to do is place cones, tennis balls or whatever at different distances, even in a zig-zag formation and place the piles on the targets in sequence. dump and enjoy !